Navigation
53 Users online :: 53 Guests and 0 Registered
Most popular FAQs 
- Can my ONKYO amplifier or receiver drive 4 ohm ... (64209 views)
- Can I connect an HDD drive to the USB ... (63941 views)
- Are there any compatibility problems with Panasonic G10 and ... (62089 views)
- Which advantage has the ONKYO Universal Port? (60218 views)
- Can I use the receiver TX-SR 506/507/576/577/605/606/607/705/706/707/805/806/875/876 and TX-NR ... (58926 views)
- Can I use Audyssey with only 5.1 speakers? (58660 views)
- The remote control of TX-SR 505/507/577/605/606/607/etc cannot control my ... (58491 views)
- Is upscaling possible at TX-SR706/707/806/875/876 and TX-NR 807/905/906 also ... (56806 views)
- Using HDMI input with my receiver TX-SR 507 and ... (56609 views)
- Is it OK to put a magnetically shielded speaker ... (56273 views)
Latest FAQs
- Is there anything to bear in mind then updating ... (2009-10-27 14:30)
- Can I use the DS-A3 (docking station for iPod) ... (2009-10-12 11:22)
- Are there any compatibility problems with Panasonic G10 and ... (2009-08-20 13:23)
- Which advantage has the ONKYO Universal Port? (2009-08-07 15:17)
- Is it OK to put a magnetically shielded speaker ... (2009-08-07 14:33)
Sticky FAQs
Home Theater » AV Receiver
ID #1005
When I use Audyssey to set up my system the subwoofer does not come on straight away and Audyssey does not see it. Why is this?
Most active subwoofers have an auto standby and the Audyssey test signal does not always activate the sub. Set the sub power to ON then run the test tones and switch back to auto power mode when the calibration is finished.
Last update: 2009-08-07 13:55
Author: FAQ Admin
Revision: 1.0
